Hi guys! Today, I will mirror the details on the knee mechanism, clean up then do a progress test fit. So here are updates on Project Devil Gundam! More Details I add the same details on the other side

Hi guys! Today, I will clean up the knee mechanism and then add some more details. So here are updates on Project Devil Gundam! Cleaning Up First, I trim off the edges using hobby knife and correct some

Hi guys! Today, I will detail the knee mechanism a little bit more with pla plates and some quick trim. So here are updates on Project Devil Gundam! Detailing Knee Mechanism First, I start sketching some

Hi guys! Today, I will prep the connector for the other piston casing then do a quick test fit. So here are updates on Project Devil Gundam! Connector Prep Work I have adjusted the connectors so that they

Hi guys! Today, I will cement the piston casing with its connectors and then I will trim the other leg. So here are updates on Project Devil Gundam! Cementing Process Since the surface is a curve, I prefer

Hi guys! Today, I will do a couple of adjustments on the connector and piston. So here are updates on Project Devil Gundam! Adjusting the Connector While trimming the bottom leg, I keep testing it with

Hi guys! Today, I will finish the connector then trim the bottom leg to fit the connector. So here are updates on Project Devil Gundam! Trimming the Bottom Leg I will trim the bottom leg again to fit in

Hi guys! Today, I will finish the connector then trim the other leg then do a progress test fit. So here are updates on Project Devil Gundam! Finishing Connector I have prepped all the pla plates to make

Hi guys! Today, I will trim the bottom leg to make some space where the connector can slide in later. So here are updates on Project Devil Gundam! Markings I have marked the bottom leg using scribing pen

Hi guys! Today, I will copy paste the pla plate connector I made yesterday and do some adjustment. So here are updates on Project Devil Gundam! Copy Paste and Test Fitting First, I copy paste the design

Hi guys! Today, I will do a quick test fit then start making a connector for the piston casing. So here are updates on Project Devil Gundam! Progress Test Fit So far the details are looking good and mechanism

Hi guys! Today, I will clean up the other piston casing then do a test fit with leg mechanism. So here are updates on Project Devil Gundam! Clean Up Just like yesterday I start with removing the excess

Hi guys! Today, I will clean up the piston casing I extended yesterday. So here are updates on Project Devil Gundam! First Trim First, I will roughly file the edges of the pla plates until I get close

Hi guys! Today, I want to extend the piston casing since from the test fit I did yesterday it was a bit too short. So here are updates on Project Devil Gundam! Prepping the Pla Plates First, I prep all

Hi guys! Today, I will do a test fit to see if there is anything I should adjust. So here are updates on Project Devil Gundam! Progress Test Fit #1 Quality of the pictures isn't the best but so far there

Hi guys! Today, I will clean up and reshape the mechanism for the knee and bottom leg then do a quick trim on the bottom leg. So here are updates on Project Devil Gundam! Clean Up and Reshape First, I

Hi guys! Today I will clean up the modification from yesterday then I will reshape some of the sides and finish with a progress test fit. So here are updates on Project Devil Gundam! Trimming and Reshaping

Hi guys! Today I will cement a couple of pla plates to the mechanism for detailing purpose. So here are updates on Project Devil Gundam! Cementing Process I start with cementing these set of pla plates

Hi guys! Today I will add a few pla plate on the underside of the knee mechanism. So here are updates on Project Devil Gundam! Prepping Pla Plates I trim the edges a little bit using hobby knife then I

Hi guys! Today I will continue detailing the other leg with a few pla plates. So here are updates on Project Devil Gundam! Cementing Pla Plates First, I prep the pla plates then cement it in place using