Hello everybody, today I will be teaching you how to create your own ZCoin Paper Wallet, in a text (If you're not watching the vid or don't want to.)! First, you will want to go to this link --> http://paper.zcoin.ga/
First, you will have to do some calibrating.
It will surely be a lot of trial and error, but at one point you will get it right.
It should be almost the same length of a real ruler.
You will have to set it to portrait mode before printing.
Second, you will have to print the front of it.
You can put in your own key in, or just generate a random wallet.
Third, you will have to print the back of it.
The thing is, that you will have to flip it on the front of it, once.
After printing it, you will see that it looks like the back part is larger than the front side.
The design on the reverse side is intentionally larger than the front side so that back design will "bleed" to the edges even if your front and back sides are somewhat misaligned.
Note that you should use the front side as your guide while cutting.
Fourth, now you will have to secure your private keys!
To do that, get two tapes, not too long or short.
Now flip the private key side half twice. It should fit in as a rectangle.
This is when the tapes come in. You will have to use the tapes to make sure it doesn't pop out and show your private keys!
And there you have it. Your own ZCoin Paper Wallet!
