Welcome to my blog. Today i am sharing with you all how i sew a senator top for my brother.
Here is my first try in sewing a senator top. I have downloaded so many videos on YouTube and learn how to cut a senator top, so today i desired to give a try to it. Just to see if i can do it my self, all glory to God i was been able to vome out with something positive although i was not too perfect since i am learning.
I am planning for my daughter delication next month, therefore i am arranging cloth i am my brother will where to the locations.
I have give tailor my clothes to sew for me about four times and the keep on spoiling it so i determine not to give anyone my cloth and choose to do it my self.
That was the main reason i choose to learn it my self, therefore i choose to give a try and it really go well, new post i will update my own i sew for my self.
** Let see some steps i follow to sew a senator top**
Firstly i took him some measurements which includes
The front
I folded the material into two, to the measurements of the chest divided by 4 places pluse 2 inches sewing allowers and then mark out the full length of the dress pulse 3inches bending allowers
After marking it, i then use scissors to cut the front out.
The back
I folded the material into too.
Here in the back i added many things, for the length, i added 4 inches to the full length including the bending allowers. Then for the width, i added extra 2 inches to it for the back center bending.
Then i cut it out.
Before i proceed to cut out the shoulder, ham hole, and the round neck, i first use a sewing machine to sew the center back measurement to make the front and the back width to be the same.
After bending it, i then place the front on top of the back and then align it at the top edge, i the slite the shoulder my 1 inches.
Then cut it out, after cutting it out, since the back is longer than the front, i then pull the front to be the same at the bottom, then fold the back top to meet the top at 1inches and then clip it to stand
I then measure out the shoulder and the cut the ham hole , see photo below.
After then, i round the neck to the measurements i want.
Then cut it out, see photo below.
Here is the back and front
After that i then sew a band for both the back and front
I then cut the hand, and bend the adge. Then join the sholder and the hand to the ham hole. See photo below.
I then pipe the neck.
After piping the round neck , i then joint the body, here is the outcome of it.
Hope i try, i have learned many things and i know my next try will be better than this. Rate me work.
Hope you love it. Thanks everyone for going through.
Hope you guys will come and join with me in my daughter delication and support to open account for her.
