Ok I know it’s Wednesday but this has taken me 2 days to 3D print.
I tend to carry my drone around in a camo bag along with my Olympus Camera and a few accessories like the landing pad and filters. But it rattles around a bit and easily get damaged, so I was looking for a better solution. Once again Thingiverse to the rescue.
The box is a perfect fit for the controller.
The 3 batteries and charger.
Finally the drone slips in. With pockets for the tools spare props and SD cards.
Bang on the lid and it fits nicely in to the camo bag
And there is still room for my camera and accessories.
All in all a great little solution even if it did take 2 days to print and it’s great to combine the two hobbies.
