A while back I wrote about my best meaningful tattoos so seeing that there's another prompt on bizarre tattoos, I was all in and went to do my research. Let's just say that the seki before the research

Hi fellow Hiveians, Today I wanted to talk about the good thing about making changes to the things we use, and how we can adapt by doing so! Changing VPN Providers Changing VPN providers is one of the

A long awaited cooking post, that was mostly cheating, improvisation and intuition

DJI Mini 3 Pro Mods

Drone Hivis Skin

I CAN'T STOP DOING IT!

Are the hackers ruinning the video games? modifications brings different experiences

Copperhead All Metal hotend from Slice Engineering

Do you remember the old motorbike owned by the GIANT FACTORY Honda that was made in Thailand in 2006. ??? After I make modifications. They look cool and amazing. I took the concept of Jeep Style. And replace

So after modifying the case of the K40 laser cutter, I have to start reinstalling the guts.. Reinstalled the power supply - need to tidy the wiring stil The gantry is now back in the machine The Holgamods

So installed the new Ikea legs to the K40 laser cutter.. Turns out my old short ones fit under the bottom box thingo as well! handy

The base mod is now secured to the laser cutter.. now all i have to do is reassemble the stuff that goes inside!

Cut out of the 260mm x 240mm base tray plate a hole using the table saw and the bandsaw This is going to get a lot of use today... The 2.5mm drill piece in my impact driver Clamped in place the first piece

Here I measure out the area that needs to be cut out Using the Air nibbler tool I start to cut out the base of the K40 laser cutter sheet metal.. It only just gets through this material so it takes some

I went to my favorite store, Paramount Browns to get some Aluminium for the next part of the K40 mods Here we can see the guillotine used to cut the 3mm flat sheet aluminium into the sizes that I needed.

I have a feeling that when I work on the bed side of things, I probably should clean up some of the messy wiring in here :)

Just measuring the size of the K40 so that I can buy a sheet of 3mm aluminium to reinforce the base after I cut a hole in the bottom Side looks like 500mm Front looks like 810mm Now to get the approximate

I have made a couple of options for the bead of my laser cutter using spikes that are usually used in leatherworking Here is one where the spikes are 2.5cm tall Here is one where I am using 8mm tall spikes

I only did a few digital modifications! All the plants are on my balcony. I like the results🍀Hope you like them too☘ 🙏

I need to raise the laser tube in the back of the laser and the first mirror by about 7.5mm In order to do that I needed to take the tube out.. Turns out that you need to take apart a fair bit just to