After going through a long time, finally the machine can be installed again, the process of repairing this machine takes almost 3 years because of economic and sphere factors that are difficult to find in my area, this machine is 90% already using a new sphere because most of the problems used to be some are damaged and there are counterfeits too, that's why I decided to use new items to prevent future problems, in this part of the photo I just replaced the piston, lava, and axle as the starter, not forgetting the gasket.
These are the items and the bolts that I will install, I use among these items, there are a lot of new items because the old ones can't be used and here is also a full seal set like a magnet, I still use old stuff because there is no damage to the tub. magnets here also I find a lot of problems ranging from bolts that do not suit my needs and many of the items I need are not available in my local shop, so here I am a bit dizzy, how can I not bother that I should install this machine now forced I have to postpone tomorrow or the next few days, I hope tomorrow I can get the items I need.
This is the machine after I installed everything and thank God I got all the items I needed, I also got it outside my city, I happened to have an assignment out of town so I took the time to look for the items I needed, the items I needed. It can also not all are original because this type of motorbike is rare even though this motorbike is a HONDA brand, in the official Honda shop, this motorbike has no goods because of the lack of enthusiasts they say, because I live in a village, yes, this type of motorbike is definitely very much in demand because the goods are cheap, the engine is durable and the gasoline is also economical, what else is the unloading costs.
And this is the engine that I have explained at the top, I have cooted this machine and I plan to dip it in carbon so that it is a little memorable. because I don't like the engine to look messy because now the classic engine is not seen from power or paint, therefore I am very careful in doing it, I forget !!
The sphere of this machine is not fully installed because there are parts that I have to take to the lathe to fix the seats for a few springs.
I hope my post is useful