Pot holder: Chicken Crochet
Source : Photo taken by author Marleny LLanes
on a cell phone.
Hello to all the communities and my dear steemit fans, I hope you are having a good day. Today I bring you the step-by-step of how to make a chicken pot holder, with crochet thread, made by my mom Marleny Llanes.
Materials
| Needle (4) |
| wool yarn |
| Scissors |
Development
- To make this pot holder, we start with 5 chains and close with a sliding stitch.
Source : Photo taken by author Marleny LLanes
on a cell phone.
- Turn 1 We go up with 3 chains and weave 26 high stitches in the middle of the 5 chains.
Source : Photo taken by author Marleny LLanes
on a cell phone.
- In the second lap we made three chains and a high point in the same point of the chain that represents an increase, in the following point two high points (1 increase) and in the following point a high point, we repeat: two increases and a high point until finishing the lap.
Source : Photo taken by author Marleny LLanes
on a cell phone.
- On lap 3 we performed the same procedure as the previous lap.
Source : Photo taken by author Marleny LLanes
on a cell phone.
- On lap 4 we go up with three chains and a high point on the same point (a raise) and a high point, i.e. make a raise and 1 high point until the end of the lap.
Source : Photo taken by author Marleny LLanes
on a cell phone.
- On lap 5 and 6 we performed the same procedure as the previous lap.
Source : Photo taken by author Marleny LLanes
on a cell phone.
- For lap 7 we made low point at each point, we folded in half.
Source : Photo taken by author Marleny LLanes
on a cell phone.
Now in red color, we make the hen's crest knitting 3 chains and two high stitches in the same stitch joining the two covers, in the next stitch we make a low stitch, in the next stitch we make three high stitches in the same stitch and in the next stitch we make a low stitch. We repeat the same procedure until we finish.
Then we make the peak in orange: we start with two chains and half a high point, we make 4 chains in the next stitch we make a sliding stitch and close.
For the chin: in red color we make 3 chains and a sliding stitch and close. Up to here we join the two pieces, the rest is the two loose pieces.
To finish off we make the border, we start from the chin taking a loop we weave a chain and we make a low stitch starting with the border we weave five high stitches in the same stitch, we skip two stitches and we make a low stitch and again we make five high stitches in the same stitch we skip two stitches and we weave half a low stitch until we finish the whole border.
Source : Photo taken by author Marleny LLanes
on a cell phone.
- For the tail, we cut 16 strands of 10cm long each, tie a knot and place it as shown in the picture:
Source : Photo taken by author Marleny LLanes
on a cell phone.
Some models I make
Note: Spanish to English translation in Traductor: Deepl
@crosheille