Ringkee Apple watch bezel styling
I received only liquid waste film from Ali, body protective case, and all other wastes ... After a few tries, I came up with the next best solution.
The product I am using is Apple Watch Series 3 Aluminum Space Gray 38mm model.
The gorilla glass liquid protruded a little more than the body, and it would be cracked if I dropped it on the floor, and it cost me 300,000 Ripper.
In fact, after setting up an apple farm, I feel like I'm wearing a time bomb in my daily life.
If you drop the iPad and it crashes ... If it breaks down, it will be discarded .. (It's a bigger navel than the first generation pro. It is ...)
... However, it is hard to get out of the apple farm.
Anyway, in order to avoid the cataclysmic damage to the floor of the cement wall in order to protect the watch that does not have a kettle from the mistake which dropped to the floor as much as possible,
A total of four adhesive tapes are already inside the product, and one set of extra tapes is included.
Once you attach it, it is difficult to attach it again after detachment, and you have to use a new tape.
Although I am in a space gray color, I bought it in silver silver bezel ring (glossy silver) color to feel the sensation of silver silver.
This product is literally bezel ring, the front of the bezel is exposed. Therefore, we attached 2.5D tempered glass for protection.
I have never seen a product review that says that 3D and 4D are all covered by the bezel curved surface, but they fit perfectly on the surface. Actually, it does not seem possible.
So, the next best choice was bezel ring + 2.5D tempered glass.
The toughened glass is so small that it only protects the area where the display is displayed, and it does not cover even the bezel which is not a curved surface. This is a bit uncomfortable, but it does not look awkward because the bezel is quite a bit of a bezel.
In the above picture, you can see that the bezel ring covers most of the curved part of the liquid crystal. Thanks to that, I can reduce the phenomenon that the liquid crystal protrudes above the body case. This is similar to a case that protects your iPhone / iPad with a tough feeling.
It shows a distinctly different appearance from Ali's protective film products, which are thick enough to make a tee.
If you attach a flat tempered glass there and protect the front scratch, it will not be easily broken even if you drop it at least once or twice.
Of course, if you do not have a bad luck, you will have to pay for it at once. It's just my wish.
I hope to introduce a good product to you as well. The most important thing is the price.
If the same product came out from the B model, it would have been priced at least three times.
I am very happy because it is a product from R company instead of B company. Anyway, I finish the review more than that.
