With the floor finished, it was time to move on to the walls! A deep breath and with rudimentary tools in hand, it was time to start. This stage was surely to transform and uplift the look and feel of my van conversion.
Getting high on glue again, i used a combination of spray adhesive, a strong grab adhesive, foam glue and the odd patch of duct tape just to hold them in place. Bracing around 3 boards at a time per day (it was a long task).
Meanwhile, 8 boards later, the robotic drone of autonomy was broken with a little visitor coming to see what was going on.
And in the break, some rudimentary workings out.
The Earthwool was conveniently situated at the bottom, with the harder, more efficient 50mm board above.
A satisfying task, trimming off the foam glue. Great stuff to play with!
Taking on a new look and a fresher look. The walls were marked up for the locations of the underlying structural supports.
The van now has taken on a new look, it feels like being in some kind of satellite!
Overall, a relatively simple task, just time consuming! After a quick test drive to ensure its all still in place. I can say that this stage has silenced the van immensely to such an extent that sound suppression was not required, not to mention how warm it now is.
On to the next phase - Lining the walls.
The insulation properties: Board = 0.022 W/mK / EarthWool = 0.037 W/mK
The Complete Project so far:
My Latest Brainwave & Project
Assessing The Task
The Strip Out
Floor Preparation & Rust Treatment
Hole Plugging & Lock mending
Finalising The Floor Foundations
The Insulation Begins
Insulating The Floor