Y tuve que cambiar la bomba[ESP-ENG]

Buenas tardes amigos de Hive Motors, hoy quiero compartir con ustedes el percance que tuve con la bomba de agua de mi casa .
En horas de la tarde se acabo el agua del tanque de mi casa ( el tanque elevado que suministra el agua para toda la casa ) cuando me dispuse a prender la bomba que subsiona el agua del tanque subterráneo que tengo como almacenamiento, note que la bomba prendio y luego se apago, nuevamente la encendí y me di cuenta que se disparaba el breker donde tengo instalada la bomba , lo volví a pasar y se disparo nuevamente, decidi desconectar la bomba , pase el breker y sin la bomba conectada todo lo demás funcionaba bien, no me quedo más que desarmar la bomba para revisarla , le quite los tornillos de la tapa , retire la tapa y me di cuenta que tenía un cable despegado , procedí a lijar un poco las puntas del cable roto para unirlos nuevamente, luego arme la bomba , la probe y funciono unos minutos y lamentablemente se volvio a apagar.

Good afternoon friends of Hive Motors, today I want to share with you the mishap I had with the water pump in my house.
In the afternoon I ran out of water in the tank of my house (the elevated tank that supplies water for the whole house) when I was ready to turn on the pump that pumps water from the subway tank that I have as storage, I noticed that the pump turned on and then turned off, I turned it on again and I realized that the breker where I have installed the pump was triggered, I passed it again and it was triggered again, I decided to disconnect the pump, pass the breker and without the pump connected everything else worked fine, I had to disassemble the pump to check it, I removed the screws from the cover, remove the cover and I realized that it had a detached cable, I proceeded to sand a little the tips of the broken cable to join them again, then assemble the pump, test it and it worked for a few minutes and unfortunately

Decidi entonces ya no montarla más y dejarla para mandarla a revisar ( cuando tuviera el dinerito ) con un técnico en bombas,mientras tanto sin agua en el tanque aéreo de suministro tuve que instalar una bomba nueva que había comprado a buen precio unos meses antes y que tenía guardada previniendo esta eventualidad.

I then decided not to mount it any more and leave it to be checked (when I had the money) with a pump technician. In the meantime, without water in the aerial supply tank, I had to install a new pump that I had bought at a good price a few months before and that I had kept in reserve to prevent this eventuality.

Le quite las conecciones a la bomba dañada y se las coloque a la bomba nueva , en estos casos es bueno utilizar teflón para unir las piezas ,pero como no tenía y ya era tarde para salir a comprar decidí ponerle un poco de hilo para evitar fugas en las uniones .

I removed the connections to the damaged pump and put them to the new pump, in these cases it is good to use Teflon to join the pieces, but as I did not have and it was too late to go out to buy I decided to put some thread to avoid leaks in the joints.

Instale la bomba ( valvula check , llave de paso) en su respectiva tubería , luego la conecte a el cable de alimentación de corriente y la encendí, a pesar de que la bomba que instale es de menor capacidad (1/2 hp y la que se daño es de 2 hp ) de la que tenía y tarda un poco más en llenar el tanque por lo menos pude solucionar hasta que pueda mandar a reparar la bomba que se daño.
Hasta aquí mi post de hoy gracias por su atención.

I installed the pump (check valve, stopcock) in its respective pipe, then connect it to the power cord and turned it on, although the pump I installed is of less capacity (1/2 hp and the one that was damaged is 2 hp) than the one I had and it takes a little longer to fill the tank at least I could solve until I can send to repair the pump that was damaged.
So far my post today thanks for your attention.