Greetings to everyone in this amazing community. Yesterday I was at the market buying beads for this work. Without wasting time I want to show you how I made this beautiful bracelet for my client.
Materials used;
*Black bead (6mm)
*Pearl bead white (8mm)
*Gold bead (6mm)
*Beading needle
Scissors and Plier
*Jump rings,chian and clasp
PROCEDURES
Step 1; I took 70cm beading thread with the needle and 8 gold bead (6mm)and secured few knots and cut off the thread at the end. Then I went through 3 gold bead ( 6mm) at the right and pulled the thread and cross over to left side and went through 1 gold bead before the last bead at the end and add 1 pearl bead (8mm) and pulled the thread and position it in the middle of the flower .
Then I went through 2 gold and pulled the thread and added 3 black bead (6mm) and went back through same bead and pulled the thread and added another 3 black (6mm) and went through 1 black and 2 gold bead and pulled the thread and repeated the steps until I completed it round the flower.
Step 2; I went through the black bead and added 1 gold bead and went through the black bead and added another 1 gold bead and pulled the thread and continue until I completed the gold beads round and still went back round the previous 8 gold beads and secure few knots and cut off the trail thread.
Step 3; I tied the thread on the beaded flower and secured few knots . Then went through 1 gold bead and pulled the thread and added 3 gold and went through 2 gold and pulled the thread and repeated the steps until I reach the desired length. Then went through some beads and secured few knots and cut off the thread and repeated the previous steps on the left hand .
Finally I attached the jump rings and chain on one end and clasp on the other end.
I know my client will be satisfied. I hope you like it too
Thanks for stopping by ❤️❤️❤️
Your comments and support is very much appreciated.
