Greetings everyone. I beaded this bridal necklace yesterday but my phone battery went down before I could finished and I was not able to publish it . Without much ado I want to show how I made it.
Materials I used;
**White pearl beads size 6mm & 8mm
**Gold seed beads 12/0
**Wire
**Jump rings &clasp
**Plierand scissors
**Beaded needle
THE PROCESS
Step 1; I started by making the flowers which I used as my pendants. I cut out 120cm of fishing line and I picked up 5gold seed beads and I added white pearl beads and make two secure knots and cut off the trail thread .
Then I added 5 gold seed beads and went through the white pearl bead and through all the 5 gold seed beads and pulled the thread.
Step 2; I added White pearl bead size 6mm on and went through all the golden seed beads on the right and pull the thread and added same size of pearl bead and went through all the golden beads on the left and secured a knot and cut off the trail thread .
Step 3; I made 11 beaded flowers and set them aside.
I cut steel wire of about 80cm and put in the 11 pendants first and added 20 White pearl beads size 8mm on both sides and finally put jump rings and clasp and tied the wire many times at both ends .
Step 4; Making of the earrings. I first beaded the flowers as I did earlier.
Then I position the flower horizontally and added 1 pearl bead 6mm and went through the pearl bead on the flower and pull the thread and secure with few knots
I added 1 seed bead and the earring hook and went through the seed bead and secure few knots.
Final look of the jewelry set
Your comments and support is always appreciated.
Thanks for stopping by ❤️❤️❤️