*****************

Greetings to all steemit community receive a warm welcome to my new post

@fusionnuclear.

*****************

I am going to share with everyone how to make my project to build a machine to grind corn. I spent some time preparing and looking for everything necessary to finish my project to build a machine to grind corn and make the peeled arepa dough.

I had to buy these two new pieces, which was what I was missing to finish the project. how espuse een this post: https://busy.org/@fusionnuclear/proyectandome-para-hacer-una-maquina-para-moler-maiz

Here I show the transmission, the endless, the sprocket and the engine mounted on the transmission.

The first thing is to place this small balin inside its hole in the transmission.

Then I put the catalina and the endless.

proceed to adjust with their respective screws.

Transmission with the sprocket and endless is shown here instead.

This step is one of the most important, grease the pieces well. Do not skimp on placing enough grease, since the durability of the machine will depend on this.

Almost ready to be mounted instead.

I put the coupling between the motor and the endless.

Now if it's ready to be mounted instead.

After putting it in place I proceed to put their screws.

This is the coupling I did for the transmission and the mill.

This is the finished project

I am very well it works perfectly.

*****************

I hope you like it and thank you for visiting the post.

*****************

@fusionnuclear

Signature courtesy of @azorahai77

________________