Woke yesterday to the air lift pump finished on the #3dprinter. I am a bit concerned about the air holes being too big after scaling the thing up to fit 4" pvc. I need to get it to Isaac so he can

Yesterday morning I found a model to print that is a better bracket for my new headlight for the bike. This one holds it much better than the little clip they provide. I had to print the male Garmin quarter

I was in town again yesterday morning for more grain, a much larger load this time. 5 Barrels needed to load into the trailer. I got another nice sunrise though. The trailer managed to hold all the grain

I was in town by 5:30 yesterday morning for the group ride and was glad I brought my headlamp as it was still dark when we rolled out. The light built as we rode north. The sunrise was pretty cool looking.

Yesterday morning I was in town at Home Depot picking up supplies for jobs. Tile sealer for today and the board for yesterday. I then headed to my client's where I got the lazy susan corner cabinet measured

I did not sleep well and was up well before my alarm went off at 5am. So I was on the road by 5am headed to town for grain. Was a nice sunrise though. I had 3 barrels and 3 halves to load. I noticed a