Hola queridos amigos de Hive. Espero que la felicidad de este mes, la buena energía colme sus vidas de bendiciones y mucha paz espiritual.
La navidad en este mes nos invita a estar unidos pero también a poner en mente la creatividad. Así que partiendo de algunos materiales fuera de lo convencional vamos a recrear unos bonitos aretes de bolas de navidad. Espero les guste.
Necesitaremos los siguientes materiales:
- Bola de platico pequeña y ligera
- escarcha de colores
- Alambre de cobre
- pinzas
- gancho de aretes
- perla dorada
- vela
- encendedor
- clip
Paso a paso
1
()
Tomamos un Alambre o el clip y calentamos en la llama de la vela el material, luego debemos perforar con el clip el material de la bola de plástico.
Debemos hacer lo mismo en el otro punto medio de la bola.
2
Lu3go debemos hacer pasar por los agujeros el alambre de cobre de una medida de 8 cm aproximadamente, luego introducimos una perla dorada y le damos vuelta en su alrededor con el alambre de cobre.
3
Seguidamente en el otro extremo de alambre de cobre debemos enrollar este y formar un área circular con el alambre. También insertamos el gancho del arete.
4
Después debemos aplicar el brillo de uña en toda la superficie de la bola y después debemos agregar sobre esta las escarchas.
Realizamos el otro par y de wsta manera obtenemos el arete.
Espero que les guste! Saludos amigos!
- Las imágenes me pertenecen
- Traductor: Deelp traslator
- Edicion: Canva
Hello dear friends of Hive. I hope the happiness of this month, the good energy fills your lives with blessings and much spiritual peace.
Christmas in this month invites us to be united but also to put in mind the creativity. So starting with some unconventional materials we are going to recreate some beautiful earrings of Christmas balls. I hope you like it.
We will need the following materials:.
- Small, lightweight plastic ball
- colored frosting
- Copper wire
- tweezers
- earring hook
- golden pearl
- candle
- lighter
- paper clip
Step by step
1
()
We take a Wire or the clip and heat in the flame of the candle the material, then we must pierce with the clip the material of the plastic ball.
We must do the same on the other middle point of the ball.
2
Lu3go we must make pass through the holes the copper wire of a measure of 8 cm approximately, then we introduce a golden pearl and we turn it around with the copper wire.
3
Then on the other end of the copper wire we must roll it and form a circular area with the wire. We also insert the earring hook.
4
Then we must apply the nail glitter on the whole surface of the ball and then we must add on this the frostings.
We make the other pair and in this way we obtain the earring.
I hope you like it! Greetings friends!
- Images belong to me
- Translator: Deepl Traslator
- Editing: Canva