You'll need is the height 1 of the fence in feet - 1 so a -foot 1 fence needs bands at the corner post 1 double up the hardware for each direction at the top alternate the cups of each brace band one up and one down on the line posts add the offset post tops with the offset loop toward the outside then Metal Corner Brackets we'll just slide our top rail through 1 the post top into the rail end cup and tighten the bolt we'll just keep adding our top rails sliding each rail over the narrow end of the previous rail at the 1 end we'll mark the length of the last 1 top rail and cut to fit then just tighten the end cup to secure the top rail with the top rail set add tension wire along the bottom it should be about two inches off the ground and on the same side as the fabric. Large metal corner brackets, Metal corner brackets for wood, Heavy-duty metal corner brackets, Long metal corner brackets, Metal corner brackets Screwfix, Decorative metal corner brackets, Corner brace brackets, L brackets.
Outdoor screws Screwfix, Railway sleeper brackets, Screwfix railway sleeper brackets, Railway sleeper brackets b&q. Now we'll install our fabric we'll start by laying it out on the outside of our fence poles on the ground virtual slide attention bar through the first row of diamonds secure it to the terminal posts with the tension bands and carriage bolts after that we'll see 1 in the fabric up against the post and 1 pull out any excess slack I'm going to 1 attach a few wire ties to the top rail 1 to help hold it in place if you have to remove any excess fabric loosen a strand and twist it out to secure the other end insert a tension bar about three feet from the end of the fabric temporarily add a tension band to the terminal post 1 and Hoka come along to it hook a stretcher bar to the tension bar and attach the come-along to tighten the 1 fabric it's tight enough when you can squeeze it just a little bit once it's tight enough again remove the excess fabric now we'll pull the rest of the fabric to the terminal post an insert a 1 tension bar through the fabric and 1 tension bands 1 1 then we'll just tighten our nuts and 1 bolts and remove our come-along stretcher bar and temporary tension band along the run Outdoor Screws will attach the fabric to the posts with fence ties for the posts we'll go about every 1 inches on the top rail.
We can 1 go every two feet you can just eyeball it it doesn't have to be exact 1 once you've done that you can secure the fabric to the tension wire with wire clips I use the little pair of pliers for this process with the first section 1 complete you can move on to the other sections the fabric should install pretty easily with only a few tools and maybe a helping hand just be sure you 11 don't stretch it too tight 1 and don't skip on those wire ties and clips they prevent pets from pushing out the bottom of the fence you might have a section of fence that's longer than the chain-link fabric rolls like.