CNC

Another crib board finished. This one is on maple and padouk. I've got my design pretty near zeroed in and can cut these out in no time. The wood prep is the real time consumer. This is my first time trying

Finished up this nifty little clock today. This started as a piece of wood that had a crack down the middle. It wasn't completely broken in two, but I could tell that it wasn't good enough to trust it

This was an interesting project I made as an Xmas present for my mother. So far my biggest CNC carve yet coming in about 19x21 inches. I poured a bit of epoxy around the butterfly to give it a bit of color

Here's a few photos of a fence and pergola I made this year. I put up a pretty hasty fence about 2 years ago with the intent of finishing this sooner, but other projects got in the way and the other fence

I'm just finishing up a few CNC carves and signs for various people. All that's left is a hanger on the backs and they're ready to go. I've got a few more at various stages as well that I'll post as they

Testing out a CNC live stream.

I finally got the CNC router back up and running last night. Here's the details on what happened last week It was quite the task. I ended up troubleshooting the whole mess for 2 days before deciding that

Well, my CNC router has been down nearly a week. Today's the day I (hopefully) get it back up and running. The old laptop I was using to run the router was not in the greatest of shape. It took nearly

I finally have these two projects stained and sealed. Both pieces are cut from the same piece of walnut slab. Painting is not my favorite part of any project and I always seem to procrastinate finishing