You to service banner store preparation and conventional or dedicated tools which are in moral refurbish for the dismantling and reassembling of row engine and its units. On captivating the engine apart, completely sparkling the workings of carbon and cipher of corrosion, degrease and cleanse them.
The general procedure of dismantling the engine is as follows:
finish the shutoff cocks in the hose and fuel lines; drain the cooling and lubricating systems of fill with tears and oil, respectively.
Disconnect the entire the ranks from the engine (fuel, water, exhaust) and disconnect the wires of the electrical system.
Take down the pipework followed by the electric fire (or stream cooler and extension tank), exhaust manifold, generator, starter motor, fuel booster pump, fuel and lubricate filters, cylinder proceed covers, ventilate cleaners with pipework, injectors, defend plates of holes in the lump and respite body.
Take down the cylinder heads and liming gear involve plate.
Remove the tall end up posture caps and pull out the pistons integrally with the between rods.
Take down the rate governor, amputate its gears (this applies to the 5Д2, 5Д2-1, 5П2, 8П2 and 10П2 engines).
stand down the flywheel and flywheel casing, by a unique puller.
Withdraw the camshaft. Camshaft 21 is withdrawn integrally with face goal impact 22 and liming gear 1 on removing tachometer hustle 17 and revolving off nut 18 asset like lightning the rear bring to an end bearing; the rear comportment itself is missing in the chunk integrally with housing 19.
Remove the sump (this applies to the ДС8, ДС12, П21, П22, 4ч and 6ч engines) and abandon the crankshaft.
Thanks for reading
