today I show you my overlay.
If you missed the 4th part (mdf panel); here it is:
Project: Casemod - Hardware@Wall - MDF panel
I will install an additional overlay to my mod.
I hope this will give the project a special look, a little bit 3D
The overlay had the same size as the main panel and was made out of 3mm MDF.
I used my CAD document, cut out the areas and fixed it to the panel.
With a spray can I transferred the sections to the overlay.
To identify the parts better, I highlighted them with a red marker.
At the end I cut out everything with the jigsaw.
I cut the black leather to the right dimensions and applied glue to the two parts.
After the drying time was over I brought them together
After 24h I cut out the different parts und glued them to the back of the overlay.
I didn't use a stapler because the overlay is not thick enough.
But no problem the glue was insanely strong
And this is the final overlay.
I'm going to work with plexiglass.
Servus and cu next time.
