today an update of the piping.
If you missed the 8th part (Leather); here it is:
Project: Casemod - Hardware@Wall - Leather
This was my first version of the square profile tubes.
I disassembled them and used it for version 2.
Version 2 has the focus on the side covers.
I used 6mm plexiglass in which I drilled a 12mm hole.
After that I cut a 1/4 thread into the workpiece.
Sawed, sanded and polished.
Version 2 was not connected from the top. I used 90 degrees Fittings on the side.
I mounted them and so I could easier measure the length of the profile.
And this is version 2.
Now gluing and hoping.
I'm going to continue with the multi-skin sheets
Servus and cu next time.
