CYLINDER HEAD

friendship steemit all little about hearing of the head of motorcycle cylinder

1. Remove the spark plug wire by pulling on the cable shoe, do not pull on the cord because it can damage the spark plug wire.

1. Remove the cylinder head cover.
2. Loosen the bolts of the valve collector gra

dually, three or four times, based on the order of the moment. (note the picture)

1. Remove the pushrood and place the pushrood in the correct order according to the order in each cylinder valve so as not to change its position, it is because the pushrood state in each valve is different. If necessary, number each pushrood by using sticker paper.
2. Loosen the cylinder head bolts gradually two or three times, according to the order number (with a circular / mosquito coil system). (Note the picture).
3. Remove the cylinder head from the cylinder block, if it is still difficult when removing / lifting the cylinder head, insert a screwdriver between the cylinder head and the cylinder block and then diungkit. (note the picture).
4. Remove valve and valve spring from the cylinder head, by pressing the valve compresser and then unlock the spring. After the key is released, release the spring valve compressor carefully so that the spring does not jump, then remove the valve and the valve spring from the cylinder head.