Was in need of a break, and couldn't for the life of me think of a good 3D printable design idea.
Well, ok, I could think of a few, but most required manipulating relatively complex models that would have slowed my computer to a crawl, so I just went with this (non-printable / very difficult to print) idea instead.
It's a sphere made entirely using a primitive form, combined with a lot of Beveling of points, lines and faces, as well as some Extrusion here and there.
Then, I rounded the entire thing and cut half away, to fuse it with a primitive rectangular shape.
here it is on Vectary
and a view from the inside:
All images, as well as the 3D model, are released under a CC-BY-NC-SA 4.0 License
Hmmm...
I need to make myself a banner with my Ethereum address in it when Vectary comes out with that big update...
For now : peterbock.eth