Source: https://en.wikipedia.org/wiki/Distributed_Bragg_reflector
Time-resolved simulation of a pulse reflecting from a Bragg mirror.
A distributed Bragg reflector (DBR) is a reflector used in waveguides, such as optical fibers. It is a structure formed from multiple layers of alternating materials with different refractive index, or by periodic variation of some characteristic (such as height) of a dielectric waveguide, resulting in periodic variation in the effective refractive index in the guide. Each layer boundary causes a partial reflection and refraction of an optical wave. For waves whose vacuum wavelength is close to four times the optical thickness of the layers, the interaction between these beams generates constructive interference, and the layers act as a high-quality reflector. The range of wavelengths that are reflected is called the photonic stopband. Within this range of wavelengths, light is "forbidden" to propagate in the structure.
Calculated reflectivity of a schematic DBR structure
The DBR's reflectivity, , for intensity is approximately given by [1]
where and are the respective refractive indices of the originating medium, the two alternating materials, and the terminating medium (i.e. backing or substrate); and is the number of repeated pairs of low/high refractive index material. This formula assumes the repeated pairs all have a quarter-wave thickness (that is , where is the refractive index of the layer, is the thickness of the layer, and is the wavelength of the light).
The frequency bandwidth of the photonic stop-band can be calculated by
where is the central frequency of the band. This configuration gives the largest possible ratio that can be achieved with these two values of the refractive index.[2][3]
Increasing the number of pairs in a DBR increases the mirror reflectivity and increasing the refractive index contrast between the materials in the Bragg pairs increases both the reflectivity and the bandwidth. A common choice of materials for the stack is titanium dioxide (n ≈ 2.5) and silica (n ≈ 1.5).[4] Substituting into the formula above gives a bandwidth of about 200 nm for 630 nm light.
Distributed Bragg reflectors are critical components in vertical cavity surface emitting lasers and other types of narrow-linewidth laser diodes such as distributed feedback (DFB) lasers and distributed bragg reflector (DBR) lasers. They are also used to form the cavity resonator (or optical cavity) in fiber lasers and free electron lasers.
TE and TM mode reflectivity[edit]
Total reflection map as function of incident angle and dimensionless frequency. Parameters of the systems: ε = (11.4, 1.0), period of one layer is d = 0.2 + 0.8 = 1, total number of periods is 6. Left half represents TM reflection with a Brewster's angle showed as a white dashed line, right half represents TE reflection.
This section discusses the interaction of transverse electric (TE)
and transverse magnetic (TM) polarized light with the DBR structure, over several
wavelengths and incidence angles. This reflectivity of the DBR structure (described below)
was calculated using the transfer-matrix method (TMM), where
the TE mode alone is highly reflected by this stack, while the TM modes are passed
through. This also shows the DBR acting as a polarizer.
For TE and TM incidence we have the reflection spectra of a DBR stack, corresponding
to a 6 layer stack of dielectric contrast of 11.5, between an air and dielectric layers.
The thicknesses of the air and dielectric layers are 0.8 and 0.2 of the period, respectively.
The wavelength in the figures below, corresponds to multiples of the cell period.
This DBR is also a simple example of a 1D photonic crystal. It has a complete TE band gap, but only a pseudo TM band gap.
Bio-inspired Bragg reflectors[edit]
Duration: 2 minutes and 4 seconds.Example of color change in Bragg reflector with change in humidity and comparison to biological structure.
Bio-inspired Bragg reflectors are 1D photonic crystals inspired by nature. Reflection of light from such a nanostructured matter results in structural colouration. When designed from mesoporous metal-oxides[5][6][7] or polymers,[8] these devices can be used as low-cost vapor/solvents sensors.[9] For example, colour of this porous multi-layered structures will change when the matter filling up the pores is replaced by another, e.g., replacing air with water.
Bragg's law – Physical law regarding scattering angles of radiation through a medium
Bragg diffraction – Physical law regarding scattering angles of radiation through a medium
Diffraction – Interference phenomenon of waves
Diffraction grating – Optical component which splits light into several beams
Dielectric mirror – Mirror made of dielectric materials
Fabry–Pérot interferometer – Optical device with parallel mirrors
Fiber Bragg grating – Type of distributed Bragg reflector constructed in a short segment of optical fiber
Photonic-crystal fiber – Class of optical fiber based on the properties of photonic crystals
Vertical-cavity surface-emitting laser – Type of semiconductor laser diode
Photonic crystal sensor
^ Sheppard, C.J.R. (1995). "Approximate calculation of the reflection coefficient from a stratified medium". Pure and Applied Optics: Journal of the European Optical Society Part A. 4 (5): 665. Bibcode:1995PApOp...4..665S. doi:10.1088/0963-9659/4/5/018.
^ Orfanidis, Sophocles J. (2016). Electromagnetic Waves and Antennas. ECE Department, Rutgers University.
^ Osting, B. (2012). "Bragg structure and the first spectral gap". Applied Mathematics Letters. 25 (11): 1926–1930. doi:10.1016/j.aml.2012.03.002.
^ Paschotta, Rüdiger (February 11, 2005). "Bragg Mirrors". Encyclopedia of Laser Physics and Technology. RP Photonics. doi:10.61835/hac. Retrieved May 1, 2009.
^ Bertucci, Simone; Megahd, Heba; Dodero, Andrea; Fiorito, Sergio; Di Stasio, Francesco; Patrini, Maddalena; Comoretto, Davide; Lova, Paola (May 4, 2022). "Mild Sol–Gel Conditions and High Dielectric Contrast: A Facile Processing toward Large-Scale Hybrid Photonic Crystals for Sensing and Photocatalysis". ACS Applied Materials & Interfaces. 14 (17): 19806–19817. Bibcode:2022AAMI...1419806B. doi:10.1021/acsami.1c23653. ISSN 1944-8244. PMC 9073830. PMID 35443778.
^ Guldin, Stefan; Kolle, Mathias; Stefik, Morgan; Langford, Richard; Eder, Dominik; Wiesner, Ulrich; Steiner, Ullrich (July 6, 2011). "Tunable Mesoporous Bragg Reflectors Based on Block-Copolymer Self-Assembly" (PDF). Advanced Materials. 23 (32): 3664–3668. Bibcode:2011AdM....23.3664G. doi:10.1002/adma.201100640. ISSN 0935-9648. PMID 21732558. S2CID 10065931.
^ Ghazzal, Mohamed N.; Deparis, Olivier; De Coninck, Joel; Gaigneaux, Eric M. (2013). "Tailored refractive index of inorganic mesoporous mixed-oxide Bragg stacks with bio-inspired hygrochromic optical properties". Journal of Materials Chemistry C. 1 (39): 6202. doi:10.1039/c3tc31178c. ISSN 2050-7526.
^ Lova, Paola; Manfredi, Giovanni; Boarino, Luca; Comite, Antonio; Laus, Michele; Patrini, Maddalena; Marabelli, Franco; Soci, Cesare; Comoretto, Davide (March 10, 2015). "Polymer Distributed Bragg Reflectors for Vapor Sensing". ACS Photonics. 2 (4): 537–543. Bibcode:2015ACSP....2..537L. doi:10.1021/ph500461w. hdl:11696/32604. ISSN 2330-4022.
^ Wang, Hui; Zhang, Ke-Qin; Wang, Hui; Zhang, Ke-Qin (March 28, 2013). "Photonic Crystal Structures with Tunable Structure Color as Colorimetric Sensors". Sensors. 13 (4): 4192–4213. Bibcode:2013Senso..13.4192W. doi:10.3390/s130404192. PMC 3673079. PMID 23539027.
Archived URL: https://en.wikipedia.org/wiki/Distributed_Bragg_reflector
�� CONTENT HASHES:
SHA-256: c111130a614be1b76c68c50a8468b38a38fe03156664dd088471532c4ccccaa1
BLAKE2b: efe330186456357bacf6322850e2466dda370f43438373154e865e8db3b75888
MD5: 43d6e1acb3c432a65cad334b66f0b4b3
�� TITLE HASHES:
SHA-256: a5668bc087f2f378acc2186fc7720ebe3900e09956aa9a1708ad8306a39d5e5c
BLAKE2b: 035bc8bcde9f0225b1233a12556e710d19f92222d922a4cb0501982abe7b6ccd
MD5: eeb7f868b645a9ecc2d696e53f0d2297
�� INTEGRITY HASHES:
SHA-256: 503a5440fbfcf586a39cfbcce7e23af3ab21327178b80e0c97b0902e7789d6c0
BLAKE2b: 0639e9ff8a22a45a2dd1f626a94ab1f152097e1e105e7000fa7c14367fe6d701
MD5: 89fab4f2a0abaf8e12193c4ea7f8b2ea
Archived with ArcHive - Client-side cryptographic archival system