Hello good people of hive and DIYHub.
I'm here again to share with you the tutorial for this bugle bead bracelet. This bracelet is so easy to make and doesn't waste much time.
The design “rhombus shape” was inspired by my Floor tiles design. The result was more like it was on my mind. I had bugle beads and have never used them. But today, I finally found out what to do with them 😃💡. The tutorial is somewhat tricky but you can get used to it because it is more of repeated process.
Required Materials
Black Bugle Beads 4mm(BBB)
Black Seed Beads 11\0 (BSB)
Black Glass Beads 4mm (BGB)
Beading Needle
Beading Thread
Scissors
Pliers
Time ⏲️ to Start
Pick up 4 BBB and secure very strong knots then go through one of the BBB and add one BSB and go through the next BBB… just do that for the first square. Then go through one BSB and add 4 BBB. Do what you did at first. Repeat this square formation 4 times to form another square like this 👇🏾
Repeat this process till you get your desired length.
Now, when you are done, get to one end where you should have 2 sharp edges then pick up 6 BSB and cross over to the other side then come back to the middle of the 6 beads and pick up 18 BSB and form a circle by going up through the last BSB.
This process depends on the size of your glass bead.
Now go to the other end of the work and pick up 6 BSB and go to the middle and pick up 1 BBB,1 BGB, 1 BSB.
This is what the result looks like.
Thanks for coming this far.
Byeeeeeee❤️❤️❤️.