Liquor bottle, with corrugated cardboard.

imargasa(64)

Published in

DIYHub

Words

478

Reading

3 min

Listen

Play

Hello great family of the DiyHub community, I feel very grateful and happy to be here sharing my creations with you, I have also learned a lot from my colleagues, who, like me, are dedicated to sharing each of their ideas. I am here again to show you a new creation that I made, about a month ago I made a football topper, the first time that I made a design like this. This time I dared to make a bottle of liquor, the truth was that it took me a bit of work, I didn't know how to shape it upwards in order to give it the shape of a bottle, apart from that I chose corrugated cardboard to make it and that cardboard is a bit hateful, the important thing was that I found the way and achieved it, as my mother says, “everything is possible, nothing impossible”. Now it is very fashionable to decorate cakes with impressions of corresponding designs. I used a label, but in this case it was not printed, I just peeled it off an empty bottle, which was in good condition.

FotoJet (3).jpg

Materials:
Label.
Yellow corrugated cardboard.
Green frosty Eva rubber.
Rule.
Pencil, scissors.
2 Sticks high.
Hot silicone.

FotoJet (4).jpg

Step 1:
I made a measurement, to get a rectangle, that was 30 cm long x 23 cm wide, when cutting the corrugated cardboard it would look like this. Then I made another measurement that was 10 cm long, so I passed a line, dividing it 3 by 3, and in each of the lines I made an opening.

FotoJet (5).jpg

Step 2:
Glue each of the strips, one on top of the other until the cardboard is closed, I covered it with hot silicone to place a lid underneath. Then cut a strip 12 cm long x 4 cm wide, to cover the edge of the bottle, folding inwards, it is like this.

FotoJet (6).jpg

Step 3:
This is the label that I will use, I placed it on top of the frosty Eva rubber, to mark and remove a square, after having cut, I measured 5 ml on each side, and cut, leaving a border around it, and glued to the label.

FotoJet (7).jpg

Step 4:
here I glue 2 height sticks, one on each side, thus to complete this beautiful work, I glued the label in the center part, and thus concludes my work today, I hope you liked it, thank you.

FotoJet (8).jpg

The photos were taken from a Canaima tablet.

Collage making program: Fotojet Link
Translated from google translator Link
Photo editing program: PhotoFiltre 7

Las fotos fueron tomadas desde una tablet Canaima.
Programa para hacer el collage: Fotojet Enlace
Traducido del traductor de Google Enlace
Programa para editar fotos: PhotoFiltre 7

I say goodbye until another opportunity.
Thanks for your support.

Me despido hasta otra oportunidad.
Gracias por su apoyo.