While I was showing components of the Jetbot, I was asked whether I would put them together, the answer was "YES". So now I am going to show the steps of assembling this little so called "Robot". I think it is more like a car than a robot.
在過去的一段時間中, 當我仍是每天的在展示這車的部件時, 有位大哥大問我會否把車組裝起來. 這個當然是會啦. 現在就開始示範如何組裝這車.
Before we install Jetson Nano on Jetbots, there were a few pre-configuration steps done.
在把Jetson Nano安裝在Jetbot上之前，有幾個設置步驟要先行做好。
First of all, prepare a SD card that already loaded with image.
首先當然是要準備好已經載有鏡像的SD卡。
Insert SD card to the card reader as the back of Jetson Nano.
將SD卡插入Jetson Nano背面的卡槽中。
Then complete configuration at the web-based interface.
然後就要到網頁介面去做好設定。