9kg Trom dryer disassembler
I did it until I removed the drum once.
Assembly is a bit worrying but not too difficult.
You said you only saw 9kg fans, but on the right side (when you saw it at the door)
I try to blow it with the left condenser.
To see it with an endoscope
Go down to the right and pass the fan
I have to turn to the left and I want to be impossible.
Just before opening Pandora box
The laundry will be my job if I do not make it to my wife today.
=================
I did not clean it, but it is clean.
It is like a year or two.
The floor under the condenser seems to be good, so I have to unpack it ... I want to take the condenser copper pipe and I want to ride it ...
==========
I can not see the condenser and it looks good.
I tried to open the lid with drain pump next.
The components seem to be roughly equivalent to water + dust.
I often collect a lot of water, clean it often, and often discharge it, so I can maintain my own cleanliness ...
I use a drainage trough Antsucho drain.
The kids are overflowing in the laundry and turn around a couple of times a day or two.
I need to clean the drain pump side dirt and double filter and then press the front of the pen.
==========
I thought I had an endoscope at home ....
Let's also check the bottom of the condenser.
It's charging.
===============
Endoscopy confirmed that the drain is similar to the side of the pump with a lot of dust + water ... (Add the picture later)
I cleaned it.
Throw water to the bell on the side of the condenser to the bellows
Inhalation of dust coming to the drain pump side
I did it until the dust came out ...
The results are a bit impractical.
I do not get a lot of dust in the water;
There are many people who are just wondering 9kg.
If you do not smell it, you can just use it.
I think it will be easier to remove the condensed water because the dust is blowing frequently.
=======
Assembly completed .. Normal operation
One tip is clogged with a plug at the bottom center of the rear of the dryer
When opened, it connects to the condensate water tank on the side of the drain pump.
If you are concerned about mold, here is a hot water brush
Put the sprayer in your leg and pull out the dust.
