Hello. Here is my new post!
Today I wanna show you my microcontroller I have build one year ago in school.
It looks like this:
Ignore the yellow piece of paper ^-^
The PCB was made by a company and the layout was made by my teacher. The soldering was my part xD.
I know some parts are not in perfect position.
Area 1 shows the voltage regulation. It converts the input voltage to 5V
Area 2 shows the outputs. Two ribbon cables at the right and at the top there is a brown plug strip. It is used for the I2C bus-system.
Area 3 shows the processor itself and all necessary components to make it work. There is also a D-Sub plug to programm the processor.
There are three times 8 LEDs, 4 push buttons and 2x8 DIP switches. Why always 8 LEDs and 8 DIP switches together. Because you can control one byte at a time (8 Bits) because it is a 8 Bit processor.
The processor is programmed with the software "keil" Website
The language is Assembler (it is difficult and not easy to understand)
cseg at 0
mov P3, #255
mov P1, #255main:
mov A, P3
rr A
rr A
mov P1, A
ljmp main
endThe first line says that the processor should start at the beginning of the memory.
The next two lines write the decimal value 255 -> 1111111 in binary into the port 1 and 3
Notice: This is a low active microprocessor (1 = low, 0 = high signal)
Now the two ports are completely off!
After that we set a jumppoint (main)
In main we now read from port 3 (the 4 buttons on the IO card) and write the value in the accumulator (1 Byte memory)
The processor can only do operations with values in the accumulator!
Now it gets tricky.
The value from the red button is: 1111011<- thats the value in the accumulator. If we know write this value to port 1 this LED lights up:
But we want the far right LED to light up when we press the red button.
with rr A we shift the byte one to the right:
11111011 -> 11111101
and another time:
11111101 -> 11111110
Because now the right LED lights up!
after that the programm jumps back to main and the process starts over again.
If you release the button the value is: 11111111 so the LED turns off!
I am using the software AtmelISP and a USB to Serial converter to programm it.