Hi,dear HIVErs.
Today was a bit hastened morning.As soon as i arrived i had to quickly setup second phase milling for 4 similiar pieces.
Also had to make an aluminium piece so i can tighten it properly since the pieces are rounded and the vice would not do the job.
The phase lasted about 5 minutes per piece but the whole thing lasted about 4 hours because of the seting up necessary to finish the pieces within tolerance.All sides are within 0.05mm.
And again,all the pieces are finished and ready for delivery.
Thank you for reading.
Hope you enjoy this kind of content.
Talk to you soon.
