Devil Gundam: Scratch Building Knee [Leg Modification - Part 57]

Hi guys!

Today I will reshape the edges then cement the rest of the sides. So here are updates on Project Devil Gundam!

First. I remove any excess pla plates that are sticking out using hobby knife then file to finish. Next I start to reshape the edges so the pla plates will it in between them.

I slowly file the edges to make sure that the pla plates will nicely fit in between them. Rinse and repeat on all the edges until all the pla plate can fit nicely.

I already test fit all these pla plates with the knee and so I can cement them in place. I use regular cement in between the pla plates and thin cement to clean up the surface a little bit as usual.

I will let the cement cure overnight as always then tomorrow I will clean it up. After that I will test fit the knee to see if I need to make any adjustment then I will start detailing the knee.

And so this is my updates for today on this Devil Gundam x Neue Ziel Project.

Keep on building! Keep on steeming! Have a nice day!