Devil Gundam: Detailing Scratch Build Knee [Leg Modification - Part 64]
Words
223
Reading
1 min
Listen
Play
8y
Hi guys!
Today I will detail the knee further using pla plates. So here are updates on Project Devil Gundam!
Today I will detail the knee further using pla plates. So here are updates on Project Devil Gundam!
Reshaping Pla Plates
Since the knee are slightly different I have to make a new one for the other knee. However, I will try to copy the design from the original. I start with drilling a hole that fits the runer then slowly trim off the excess.
Further Reshaping
Using the same method I keep trimming the excess pla plate to match the design of the pla plate.
Adjusting Custom Panel Lines
The last details on this side are the custom panel lines. After this I will copy the details onto the other side.
Then add a small pla plate on top of the knee and finally add the last pla plate at an angle on the top of the knee.
I think these details should be enough for the knee. All that's left is to prime to make it easier to check any imperfections before painting the kit.
And so this is my updates for today on this Devil Gundam x Neue Ziel Project.
Keep on building! Keep on steeming! Have a nice day!
Then add a small pla plate on top of the knee and finally add the last pla plate at an angle on the top of the knee.
I think these details should be enough for the knee. All that's left is to prime to make it easier to check any imperfections before painting the kit.
And so this is my updates for today on this Devil Gundam x Neue Ziel Project.
Keep on building! Keep on steeming! Have a nice day!
Quick access tutorial:
- Fixing broken peg using gunpla runer and several tools.
- Fixing holes using cement and plastic scraps.
- Making C-Joints using pla plates.