Hi guys!
Today I will clean up the other arm then do a few test fits on my Project Devil Gundam. So here are my updates for today.
Armor test fit
This is the first arm with the modified seat for Neue Ziel arm extension. The armor still fits perfectly so I can continue with the other arm.
Test fit with Neue Ziel arm connector
It is completely obvious but you can still see the inside
I'm still not sure if I should try to make a cover for this yet. I might make some kind of hatch mechanism to cover the hole but for now this is fine.
Cement has cured properly overnight on the other arm
Now all I have to do is clean up the excess a little bit. I could just leave it like this since nobody will see it but I like to keep things clean. Besides I will add the last pla plate so I need to prepare the surface.
Simple file will do the job
As usual take you time when working with file as they can scratch plastic with the slightest movement.
Test fit on the other arm
Cementing the last pla plate
I used some scrap pla plates. For this purpose I feel like this is the best way to go. Nobody will notice this last pla plate anyway since it will be on the other side of "the seat".
Now let the cement cure overnight
Tomorrow I will do several more test fit with the Neue Ziel and scratch build hand. And then I will of a way to connect the actual hand with the arm. So those are my updates today for my Project Devil Gundam.
Keep on building! Keep on steeming! Have a nice day