A very nice model however not the best print don't get me wrong its not horrible but its not at a level where it should be.
This printer has a very hard time with overhangs, those are the parts that print on an angel as it has no support material and has to print in thin air it can be difficult to achieve good results, however this model is designed very well with 3d printing limitation in mind but the issue is my printer.
I actually have 2 printers and one is on the way unfortunately my better one needs a wheel but its some business bullshit where its poorly designed to wear quickly and the wheels are slightly different and only offered from the manufacturer, I don't want to fall into their trap and rather look for an alternative its 3d printing after all.
My second printer is the one in a picture above its a second hand mess I purchased locally,
was my first and it was not bad at printing but was made from poor materials.
It gave me lots of issues but It was mostly the lack of experience and so i experienced lots of brakes.
But managed to get it going but then a small part got broken and I could not find a replacement, the only alternative was to use another extruder, unfortunately as I quickly found out I had to do a bit of work to make this work,
luckily at that time my other printer was still good and I was able to print some pieces to make this part fit I had to design and print a new base(orange), a new arm for the hold the level sensor(blue), an arm to extend the y stop arm as this extruder would not fit in the slot, and I also had to glue the fan down on the bottom, this set up does work but its very sensitive and the quality is not the best as you can see in the gif below
I also have another printer coming soon its a dual extruder and it can do 2 filaments at once and its more than just mixing color, you can for instance you can print a race car, and have the car be made of regular plastic while the second extruder can print with conductive filament inside the regular plastic, so no need for wires how about that .
Hope you got some value from my post,
Thanks for stopping by, your upvote, comments and resteems are truly appreciated.