In this video, we will be starting a new project. A precisely controlled, high temp oven for the lab. Firstly I will finish the bulk of the welding of the structure. Email: [email protected] Twitter:

In this video, we will demonstrate how to use ADC and PWM components in a PSoC Microcontroller. This is done on a PSoC 5LP CY8CKit-059. Github: Email: [email protected] Twitter: Patreon: ▶️ DTube ▶️

In this video we will show you the Cypress PSoC microcontrollers that we like to use for prototyping. We will show you how to set up usb serial in a PSoC 5lp and also some hardware logic. PSoC Creator

In this video, I will take you along as I go though my test and design process to make a small rocket launcher. Email: [email protected] Twitter: Patreon: ▶️ DTube ▶️ IPFS

In this video we will go over a custom HMI that we have been developing for the past couple of weeks. This will be for use in future machine builds. Email: [email protected] Twitter: Patreon: ▶️ DTube

In this video we try the proline plastidip on the same crostrek that we did last time. Email: [email protected] Twitter: Patreon: ▶️ DTube ▶️ IPFS

In this episode we build something to feed bulk filament spools into our 3D printer. Email: [email protected] Twitter: Patreon: ▶️ DTube ▶️ IPFS

In this video we give the sorter initial testing and make final tweaks to finish it up. Email: [email protected] Twitter: Patreon: ▶️ DTube ▶️ IPFS

In this video, I assemble all the electronics and wire everything together. Link to video about the micro controllers that I use: Email: [email protected] Twitter: Patreon: ▶️ DTube ▶️ IPFS

In this episode, we will wire up the electronics and finish the enclosure. Email: [email protected] Twitter: Patreon: ▶️ DTube ▶️ IPFS

In this video, we begin building the final skittle sorting machine. Email: [email protected] Twitter: Patreon: ▶️ DTube ▶️ IPFS

In this episode we begin work on an enclosure for the 3d printer. This should keep out dust, help stabilize the temperature and keep the noise down. Email: [email protected] Twitter: Patreon: ▶️ DTube

In this video we will test the concept for the skittle diverter system as well as the motor drive system. We are using the Odrive to control both the feed wheel and the diverter. Email: [email protected]

In this video, we take a look at the data that comes out of the color sensor and figure out how we will go from raw data to a color decision. Email: [email protected] Twitter: Patreon: ▶️ DTube ▶️ IPFS

This is the first part of the skittle sorting machine. We will be testing the three separate sub-systems of the machine before designing and building the final machine. So, join us as we follow this iterative

Creating a new welding table from scrap for the lab. Email: [email protected] Twitter: Patreon: ▶️ DTube ▶️ IPFS

This is a smaller side project, while we are collecting tools for the lab. Email: [email protected] Twitter: Patreon: ▶️ DTube ▶️ IPFS