RE: RE: [ESP-ENG] Fabricando con el torno un buje del distribuidor de un automóvil (paso a paso)/Making an automobile distributor bushing on the lathe (step by step)
You are viewing a single comment's thread from:

RE: [ESP-ENG] Fabricando con el torno un buje del distribuidor de un automóvil (paso a paso)/Making an automobile distributor bushing on the lathe (step by step)

angeljose2003(53)
Published in
Hive Motors
Words
12
Reading
1 min
Listen
Play
4y

Muchas gracias por tu apoyo.

Thank you very much for your support.

via hiveblog
This post was published via hiveblog. Ecency is not the originator or editor of this content and displays it for discovery purposes only.
0
@angeljose2003: Muchas gracias | Ecency