Today, this robot technology will be a very effective robot, maybe our effort is small, but it will open a great deal of modern technology in front of you.
Let's make the robot:
This robot will rebuild any obstacles in front of you and move beyond that obstacle. This technology is currently being used in any automatic robot, drone, non-human aircraft etc. This technology is also used in a vehicle without a driver. This technology is more used in robotics
The equipment which is required to build this robot ..........
(Required parts)
1.Arduino board
2.Motor driver board
3.Sarar Sensor
- Robot wheel
5.Ball wheel
6.Breadboard
- Robot body
8.Gear Motor
9.Jumper Wire
10.Drill machine
11.Screw driver
12.Screw
13.Soldering iron and lead
14.6-8 volt lithium batteries
15 Power Jack

The first step is the robot body
To make a robot body, you need two hard boards. You can buy this hard board from any hardware store,
The rectangular hardboard is 7 inches by 5 inches and the rounded hardboard will be 3.5 inches radius.
Arduino and motor driver in the rounded hard board should be screwed,
(Board drill)
Apply two gear motor screws on both side of rectangular hard board, (board will be drilled smoothly)

On the other side of the board, the ball wheel should be placed in front of two screws in front of the middle (board drill)
The four circular screws should be attached to the rectangular hardboard by the extender (board should be drilled), a radar sensor should be placed on a small breadboard and the breadboard should be placed in front of the robot chassis,
In this way, the preparation of our robot chassis will be completed,
This is the second step (electric connection)
On the electronics system, we will use any Armunion based Atmelon Board and use a motor driver board to run the robot gear motor,
The motor and the motor driver's connection point should be solder in a red and blue at two points, and these cables will be attached to the motorbike board with the help of the screw,
Arduino Connection As per the above figure, we have to connect the Arduino board with a motor driver and a radar sensor, in this case we can use the jumper wire, and if the connection is made by putting the radar sensor on the breadboard, then the battery connection and power system will be any 6 to 8 volts. Its lithium battery is the best for this robot, and the connection between the batteries and the motor driver. If | batteries + motor drivers to connect to VMS, batteries - motor vehicle drivers to connect to the GND, the power jack to the power of the arduino board.
This is the third step (programming)
Arduino Programming:
Ordino should be given to the board
Ordino programmers will have to download Ardooan software first
First, go to File and click Open and select the robot's project,
Select the Arduino board you want to use,
Arduino is using COM port to select,
The robot program must be uploaded,
Now if all is right then the robot will start running on its own and if there is any obstruction in front of it, it will signal in advance,
In this way, the work of making our robots is ces, thanks to everyone.